|
Lining material (manufacturer)
Batch number | Mode of application |
|
Dycal (Dentsply Tulsa Dental, Johnson City, TN, USA)
170517 | (1) Dispense equal volumes of base and catalyst pastes on the paper pad provided.
(2) Stir immediately to mix thoroughly until a uniform color is achieved.
(3) Complete mixing within 10 seconds.
(4) Allow the liner to set (approximately 2-3 minutes) completely. |
TheraCal LC (Pulpdent, Watertown, MA, USA)
1700002779 | (1) Apply to the operatory area of the preparation.
(2) Light cure for 20 s.
(3) Apply the adhesive agent. |
Lime-Lite (Pulpdent Corporation, Watertown, MA, USA)
160211 | (1) Apply to the operatory area of the preparation.
(2) Light cure for 20 s.
(3) Apply the adhesive agent. |
Activa BioActive BASE/LINER (Pulpdent, USA)
160211 | (1) Remove cap so that base and catalyst are at the orifice of the syringe barrels.
(2) Place a mixing tip on the automix syringe.
(3) Dispense 1-2 mm onto a pad.
(4) Dispense material directly onto the tooth surface and massage into the dentin for 20 seconds.
(5) Light curing for 20 seconds. |
Biodentine (Septodont, Saint Maur des Fosses, France)
B19471 | (1) Pour four drops from the liquid container into a capsule containing powder.
(2) Close the capsule and mix for 30 s on a high-speed amalgamator.
(3) Apply to operatory area.
(4) Wait 12 min from the start of the mix to continue other steps. |
RMGIC (Fuji II LC G.C., Europe N.V.)
1712071 | (1) The standard powder to liquid ratio is 3.2 g/1.0 g (1 level scoop of powder to 2 drops of liquid).
(2) Mixing (pull half of the powder onto liquid and mix with lapping strokes, pull in remaining powder, and mix thoroughly to a glossy consistency).
(3) Light cure for 20 seconds. |
| Control (no liner) | Apply the resin composite after the application of adhesive on the prepared dentin surface. |
|
