Effect of Nanoaluminium Nitride Ceramic Particles on Microstructure, Mechanical Wear, and Machining Behavior of Al-Si-Mg Alloy Matrix Composites Produced by Bottom Pouring Type Stir Casting Route

Table 1

Input parameters and output results.

Ex. No	CS (rpm)	FR (mm/rev)	DOC (mm)	MRR (g/min)	SR (μm)
1	1000	0.05	0.2	0.073	1.88
2	1000	0.15	0.3	0.097	1.68
3	1000	0.25	0.4	0.118	1.75
4	2000	0.05	0.3	0.081	2.02
5	2000	0.15	0.4	0.104	2.25
6	2000	0.25	0.2	0.124	2.09
7	3000	0.05	0.4	0.09	2.17
8	3000	0.15	0.2	0.112	1.59
9	3000	0.25	0.3	0.147	1.80