|
| Parameter | Value |
|
| Mass density RO (kg/m3) | 1700 |
| Initial porosity ALPHA | 0.0 |
| Crush pressure PEL (GPa) | 0.0 |
| Compaction pressure PCO (GPa) | 0.36 |
| Hugoniot polynomial coefficient A1 (GPa) | 2.1162 |
| Hugoniot polynomial coefficient A2 (GPa) | 2.3748 |
| Hugoniot polynomial coefficient A3 (GPa) | 0.5424 |
| Parameter for polynomial EOS B0 | 1.22 |
| Parameter for polynomial EOS B1 | 1.22 |
| Parameter for polynomial EOS T1 (GPa) | 2.1162 |
| Parameter for polynomial EOS T2 (GPa) | 0.0 |
| Elastic shear modulus SHEAR (GPa) | 1.002 |
| Compressive strength FC (MPa) | 2.1 |
| Relative tensile strength FT∗ | 0.1 |
| Relative shear strength FS∗ | 0.18 |
| Failure surface parameter A | 1.6 |
| Failure surface parameter N | 0.61 |
| Lode angle dependence factor Q0 | 0.6805 |
| Lode angle dependence factor B | 0.0105 |
| Porosity exponent NP | 0.0 |
| Reference compressive strain-rate EOC | 3.0E − 11 |
| Reference tensile strain rate EOT | 3.0E − 12 |
| Break compressive strain rate EC | 3.0E + 19 |
| Break tensile strain rate ET | 3.0E + 19 |
| Compressive strain rate dependence exponent BETAC | 0.032 |
| Tensile strain rate dependence exponent BETAT | 0.036 |
| Volumetric plastic strain fraction in tension PTF | 0.001 |
| Compressive yield surface parameter GC∗ | 0.53 |
| Tensile yield surface parameter GT∗ | 0.7 |
| Erosion plastic strain EPSF | 2.0 |
| Shear modulus reduction factor XI | 0.5 |
| Damage parameter D1 | 0.04 |
| Damage parameter D2 | 1.0 |
| Minimum damaged residual strain EPM | 0.01 |
| Residual surface parameter AF | 1.6 |
| Residual surface parameter NF | 0.61 |
| Gruneisen gamma GAMMA | 0.0 |
|
